Author Archives: lore

Bath screens

Bath screens – In small bathrooms, in which it is impossible to install both a bathtub and a shower cubicle with a shower tray, you can think about installing the so-called. a bathtub screen of an appropriate shape. Drzwiczki takiego parawanu pojedyncze lub składane …

Positioning of accessories by the bathtub

Positioning of accessories by the bathtub – The correct use of the bathtub also depends on the location of additional accessories at the appropriate height. A wall-mounted bathtub or bathtub-shower faucet is mounted at a height 60 cm above the bathroom floor. Wszelkie półeczki i …

Electric heaters in radiators

Most water bathroom radiators are shaped to allow the installation of electric heaters. They can heat the water in the radiator both during the heating season and also in summer, when in the central heating installation. no water is circulating. In winter so they will additionally heat the room too …

Cabin seal

Cabin seal – When building a shower cubicle from ceramic elements, you should think about the proper sealing of the walls. Usually, we build cabins in the corner, because you only need to add one wall. But this wall and the existing ones before laying the ceramic tiles must be covered with a flexible one …

The spacing of the racks

Racks in the Geberit installation system (sets) mounting rails are attached to special mounting rails screwed to the floor and wall. This significantly shortens the assembly time. However, we must remember, that when we attach two or three racks and distances within one wall …

Riser housings

Elements of the YTONG system made of aerated concrete can be successfully used to enclose all kinds of water and sewage risers.. You can in the case of, when the pipes are spaced narrowly apart, use typical U-fittings. When the pipes are more widely spaced, you will need to use z-plates …

Self-made sliding doors

Self-made sliding doors – individually designed surface. The door systems shown here include only door frame elements. Door surfaces, so to fill the framework, you have to design yourself and embed it within the framework. Fillings up to 10 mm will be retracted …

Painting equipment

Painting equipment – Industrial varnishing device.

The following operating zones of the device are distinguished:
1) disassembly preparation area, cleaning, wrapping, putty, priming the element to be varnished;
2) spray painting booth (painting);
3) accelerated drying cabin (dried);
4) processing zone …

Coating by dipping

Advantages of dipping:
This method enables quick and even coating of small ones, portable items.
Disadvantages of dipping paint:
1) a lot of material is needed for dip painting, much more than in the previously discussed methods;
2) due to the large surface area of ​​the material …